LYSAGHT TRIMLINE® Gutter

LYSAGHT TRIMLINE® Gutter

Product Description and Features

The LYSAGHT TRIMLINE® Gutter is a strong, economical gutter system, manufactured from light, strong high tensile steel. It comes in long lengths and is fast and easy to install. Available with optional slotting and all components needed for a perfect finish, LYSAGHT TRIMLINE® Gutter is an extremely flexible gutter system.

• Concealed fixing for greater attractiveness
• Designed for greater durability, longer life and compatibility with steel and tile roofs
• Manufactured from light, strong, high tensile ZINCALUME® steel and COLORBOND® steel for up to four times the life of a galvanised gutter under similar conditions
• Choice of optional slotting to allow for overflow during heavy rainfall
• Compatible with the LYSAGHT NOVALINE® Fascia System

Common Uses of this product

Gutter system for steel and tile roofs. Can be used in domestic and commercial applications.

Warnings

• It is important gutters slope towards the outlets. Without this slope 'ponding' may occur, reducing the life of your gutter
• When installing gutters,remove any metal particles or debris at the end of the day to prevent staining when the metal particles rust
• Lead, copper, bare steel and green or some chemically-treated timber are not compatible with ZINCALUME® steel or COLORBOND® steel
• The protective plastic film should be stripped off immediately on installation
• If these products are to be used in marine, severe industrial, or unusually corrosive environments contact us
• Read full details on Guidelines for using COLORBOND® steel & ZINCALUME® steel.

Product Details

Schematic

The following accessory products complement LYSAGHT TRIMLINE® gutter.

Colour Range

LYSAGHT® products are normally available in the standard range of COLORBOND® steel colours. View the standard colour range for:

COLORBOND® steel or
COLORBOND® Ultra and COLORBOND® Stainless steel or
Colour Chart for COLORBOND® Metallic steel

Please check with your local supplier regarding specific colour availability for individual products.

Important Information

Fall
Install gutters with a generous fall to avoid ponding (which reduces gutter life), but the fall should not be so steep as the be obvious to the casual observer. Fall on house guttering is often about 1:250 (12mm in 3000mm), though a steeper fall of 30:3000 should give the gutter a longer life.

Downpipe Design
The downpipe size and spacing should be determined in accordance with AS/NZ3500.3.2:1998 National plumbing and drainage: Part 3.2: Stormwater drainage - Acceptable solutions.

Adverse Conditions
If these products are to be used in marine, severe industrial, or unusually corrosive environments, ask for advice from our information line.

Metal & Timber Compatibility
Lead, copper, bare steel and green or some chemically treated timber are not compatible with this product; thus don’t allow any contact of the product with those materials, nor discharge of rainwater from them onto the product. If there are doubts about the compatibility of other products being used, ask for advice from our information line.

Sealed Joints
For sealed joints use screws or rivets and neutral cure silicone sealant branded as suitable for use with galvanised or COLORBOND® steel and ZINCALUME® steel.

Maintenance
Areas not cleaned by natural rainfall should be washed down every six months.

Clean Up
Remove all plastic cover strips from product and dispose of correctly. Sweep all metallic swarf and other debris from roof areas and gutters at the end of each day and at the completion of the installation. Failure to do so can lead to surface staining when the metal particles rust.

FAQs